Low pressure, short-cycling pump, or no water? Drain Doctor services pressure tanks, pressure switches, and control boxes for well systems throughout Northern Oklahoma.
Your pressure tank, pressure switch, and control box work together to deliver steady, consistent water pressure to your home or business. When any one of them fails, you'll notice it immediately — whether it's a pump that short-cycles every few seconds, wildly fluctuating pressure, or no water at all.
Drain Doctor Plumbing services all components of your well pressure system throughout Northern Oklahoma. We diagnose the specific failure quickly and carry common replacement parts to restore your system in a single visit whenever possible.
Short-cycling kills pumps. A waterlogged or failed pressure tank causes your pump to start and stop dozens of times per hour — burning out the motor prematurely. Replacing the tank promptly protects your pump investment.
We install correctly sized bladder pressure tanks to protect your pump from short-cycling and provide steady pressure reserves. Proper sizing is critical — we calculate the right tank for your pump and household demand.
Waterlogged or failed tanks are replaced with modern pre-charged bladder tanks. We haul away the old tank, install the new one, and verify proper system pressure before we leave.
The pressure switch tells your pump when to start and stop. A failed switch can leave you with no water or a pump that won't shut off. We test, adjust, and replace pressure switches quickly.
Control boxes manage your submersible pump's starting capacitors. A failed control box means a pump that won't start. We diagnose and replace control boxes for all major well pump brands.
Not sure which component has failed? We perform a full pressure system diagnostic — testing tank pressure, switch settings, pump output, and electrical components — to pinpoint the problem fast.
The air pre-charge in your pressure tank must match your system pressure to work correctly. We check and adjust the pre-charge during service calls and annual well maintenance visits.
A failed pressure tank bladder causes the pump to short-cycle — starting and stopping every few seconds when water is drawn. A waterlogged tank sounds solid when tapped (rather than hollow). Other signs include erratic water pressure and a pump that runs non-stop. Call +1-580-304-9653 for a same-day diagnosis.
The pressure switch monitors your system pressure and signals the pump to start when pressure drops to the cut-in point (typically 30 PSI) and stop at the cut-out point (typically 50 PSI). A failed switch causes the pump to not start, or to run continuously without shutting off.
A well-maintained bladder pressure tank typically lasts 8 to 12 years. Waterlogging from incorrect pre-charge pressure and sediment-heavy water can shorten the lifespan significantly. Annual inspection of the air charge pressure is the best way to extend tank life.
In most cases, yes. We carry common pressure tank sizes on our service trucks and can often complete the replacement in a single visit. Call +1-580-304-9653 to schedule same-day or next-day service.
Drain Doctor provides same-day pressure tank and switch service throughout Northern Oklahoma. Call now for an expert diagnosis.
We service pressure tanks and well pressure systems throughout Northern Oklahoma. Up to 150 miles from Ponca City — call to confirm coverage for your location.
Call us now or request a free estimate online — we'll get back to you within the hour.